Filter
Sort:
Show:
SINE VICE -PIN TYPE

SINE VICE -PIN TYPE

In Stock
  • Manufactured from Hardened & Ground Tool Steel .
  • Mounted on Hardened, ground rollers the vice can be inclined in the position with the help of side strap clamp.
  • The recess of 1mm depth is made in base plate for minute angle adjustment
TOOL MAKERS STEEL VICE -SCREW LESS TYPE

TOOL MAKERS STEEL VICE -SCREW LESS TYPE

In Stock
  • Hardened & Ground Steel Vice .
  • The rapid positioning notched allow the vice to be locked at any desired  position by allen key .
  • V-Grooves in jaws facilitates holding of round jobs
TOOL MAKERS STEEL VICE -SCREW TYPE

TOOL MAKERS STEEL VICE -SCREW TYPE

In Stock
  • Manufactured from selected tool steel hardened 55-60 hrc.
  • Accuracy for squareness, flatness & parallelism within 0.010mm
  • Wear plate at bottom to prevent lifting of jaw.
HIGH-PRECISION GRINDING AND CONTROL VISE

HIGH-PRECISION GRINDING AND CONTROL VISE

In Stock
A Very High Precision Grinding Vice for Accurate Grinding Jobs. Tool steel, through-hardened, fully precision-ground.
FLY TOOL CUTTER HOLDERS- TAPER SHANK

FLY TOOL CUTTER HOLDERS- TAPER SHANK

In Stock
 A fly cutter usually has two cutting heads and it is able to cut with a constant depth to face any surface to obtain a uniform surface.
FLY TOOL CUTTER TAPER

FLY TOOL CUTTER TAPER

In Stock
  • A fly cutter usually has two cutting heads and it is able to cut with a constant depth to face any surface to a obtain a uniform surface
  • fly cutters are used in automobile industry for various facing jobs
  • in motor industry fly cutters are used extensively
  • in almost all occasions they are used for the facing
3PC FLY TOOL CUTTER FOR ROUND BITS

3PC FLY TOOL CUTTER FOR ROUND BITS

In Stock
  • As the name suggest these are made for Round bits.
  • Very fine surface finish is obtain than the face mill.
FLY TOOL CUTTERS-WITH SUITABLE TOOL BITS

FLY TOOL CUTTERS-WITH SUITABLE TOOL BITS

In Stock
  • Purpose of Fly Cutters is very important in face Milling.
  • These are most commonly used by manual machinist.
Solid Angle Plates

Solid Angle Plates

In Stock
  • Manufactured from good quality seasoned casting.
  • Properly hardened & ground from all the sides.
  • Properly Machined 900Square.
  • Precision groundsides & end.
 
Iron Casted Slotted Angle Plates

Iron Casted Slotted Angle Plates

In Stock
  • Manufactured from good quality seasoned casting.
  • Properly hardened & ground from all the sides.
  • Properly Machined 900Square.
V- Angle Plates

V- Angle Plates

In Stock
  • Manufactured from good quality seasoned casting.
  • Combined Vee Block & Angle Plate.
Stepped Angle Plates

Stepped Angle Plates

In Stock
  • Hardened and Precision ground.
  • Tapped holes for clamping jobs in any position

Filter Products

Categories

Product Status